2021 Updated NSE7_SDW-6.4 Tests Engine pdf - All Free Dumps Guaranteed!
Latest NSE 7 Network Security Architect NSE7_SDW-6.4 Actual Free Exam Questions
Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
NEW QUESTION 11
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Select SD-WAN balancing strategy.
- B. Specify incoming interfaces in SD-WAN rules.
- C. Configure SD-WAN rules interface preference.
- D. Specify outgoing interface routing cost.
Answer: C,D
NEW QUESTION 12
What is the lnkmtd process responsible for?
- A. Flushing route tags addresses
- B. Logging interface quality information
- C. Monitoring links for any bandwidth saturation
- D. Processing performance SLA probes
Answer: C
NEW QUESTION 13
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )
- A. A peer ID is included in the first packet from the initiator, along with suggested security policies.
- B. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.
- C. A total of six packets are exchanged between an initiator and a responder instead of three packets.
- D. XAuth is enabled as an additional level of authentication, which requires a username and password.
Answer: C,D
NEW QUESTION 14
Refer to exhibits.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?
- A. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
- B. The guaranteed-10mbps option must be selected as the reverse shaper option.
- C. The guaranteed-10mbps option must be selected as the per-IP shaper option
- D. The reverse shaper option must be enabled and a traffic shaper must be selected
Answer: B
NEW QUESTION 15
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. Changes have been made on firewall policy ID 1 on FortiGate.
- B. Firewall policy ID 1 has source NAT disabled.
- C. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- D. FortiGate has terminated the session after a change on policy ID 1.
Answer: A
NEW QUESTION 16
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- B. The 10 Mbps bandwidth is shared equally among the IP addresses.
- C. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
- D. A single user uses the allocated bandwidth divided by total number of users.
Answer: C
NEW QUESTION 17
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
- A. Both SD-WAN member interfaces have used separate SLA targets.
- B. Port1 became dead because no traffic was offload through the egress of port1.
- C. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
- D. SD-WAN member interfaces are affected by the SLA state of the inactive interface.
Answer: C
NEW QUESTION 18
Which statement about using BGP routes in SD-WAN is true?
- A. Dynamic routing protocols can be used only with non-encrypted traffic
- B. Adding static routes must be enabled on all ADVPN interfaces.
- C. VPN topologies must be form using only BGP dynamic routing with SD-WAN
- D. Learned routes can be used as dynamic destinations in SD-WAN rules
Answer: C
NEW QUESTION 19
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. ADVPN should only be enabled on unmanaged FortiGate devices.
- B. The protected subnets should be set to address object to all (0.0 .0. o/o).
- C. Each VPN device has a unique pre-shared key configured separately on phase one
- D. On the hub VPN, only the device needs additional phase one sett
Answer: C
NEW QUESTION 20
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?
- A. The dead member interface stays unavailable until an administrator manually brings the interface back.
- B. Check interval is the time to wait before a packet sent by a member interface considered as lost.
- C. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
- D. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.
Answer: D
NEW QUESTION 21
Refer to the exhibit.
Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topology
Which two statements are correct if a user in Toronto sends traffic to London? (Choose two )
- A. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
- B. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN
- C. London generates an IKE information message that contains the Toronto public IP address
- D. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
Answer: B,D
NEW QUESTION 22
Which diagnostic command can you use to show the SD-WAN rules interface information and state?
- A. diagnose sys virtual-wan-link route-tag-list
- B. diagnose sys virtual-wan-link neighbor.
- C. diagnose sys virtual-wan-link member.
- D. diagnose sys virtual-wan-link service
Answer: C
NEW QUESTION 23
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?
- A. The web filter profile must be enabled on the firewall policy
- B. The application control profile must be enabled on the firewall policy.
- C. The URL category must be specified on the traffic shaping policy
- D. The shaper mode must be applied per-IP shaper on the traffic shaping policy
Answer: A
NEW QUESTION 24
Which statement is correct about the SD-WAN and ADVPN?
- A. Spoke support dynamic VPN as a static interface.
- B. ADVPN interface can be a member of SD-WAN interface.
- C. Dynamic VPN is not supported as an SD-Wan interface.
- D. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
Answer: B
NEW QUESTION 25
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. ADVPN should only be enabled on unmanaged FortiGate devices.
- B. The protected subnets should be set to address object to all (0.0 .0. o/o).
- C. Each VPN device has a unique pre-shared key configured separately on phase one
- D. On the hub VPN, only the device needs additional phase one sett
Answer: C
NEW QUESTION 26
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Use unique Diffie Hellman groups on each VPN interface.
- B. Configure the IKE mode to be aggressive mode.
- C. Use different proposals are used between the interfaces.
- D. Specify a unique peer ID for each dial-up VPN interface.
Answer: A,C
NEW QUESTION 27
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?
- A. The web filter profile must be enabled on the firewall policy
- B. The application control profile must be enabled on the firewall policy.
- C. The URL category must be specified on the traffic shaping policy
- D. The shaper mode must be applied per-IP shaper on the traffic shaping policy
Answer: A
NEW QUESTION 28
Refer to the exhibit.
Which statement about the trace evaluation by FomGate is true?
- A. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
- B. Packets exceeding the configured concurrent connection limit are dropped based on tfte priority configuration.
- C. The packet exceeded the configured bandwidth and was dropped based on the priority configuration
- D. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
Answer: B
NEW QUESTION 29
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It improves SD-WAN performance on the managed FortiGate devices.
- B. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- C. It acts as a policy compliance entity to review all managed FortiGate devices.
- D. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- E. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
Answer: A,C
NEW QUESTION 30
Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface? (Choose two )
- A. FEC is useful to increase speed at which traffic is routed through IPsec tunnels.
- B. FEC improves reliability which overcomes adverse WAN conditions such as noisy links.
- C. FEC transmits additional packets as redundant data to the remote device.
- D. FEC transmits the original payload in full to recover the error in transmission.
- E. FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss
Answer: B,C
NEW QUESTION 31
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- B. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- C. It ensures route tags match the SD-WAN rule based on the rule order
- D. It tags each route and references the tag in the routing table.
Answer: C
NEW QUESTION 32
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?
- A. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.
- B. Use the performance SLA targets to detect latency and jitter instantly.
- C. Configure an SD-WAN rule to load balance all traffic without VoIP.
- D. Place the troublesome link at the top of the interface preference list.
- E. Choose the suitable interface based on the interface cost and weight.
Answer: A,B
NEW QUESTION 33
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Select SD-WAN balancing strategy.
- B. Specify incoming interfaces in SD-WAN rules.
- C. Configure SD-WAN rules interface preference.
- D. Specify outgoing interface routing cost.
Answer: C
NEW QUESTION 34
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers. The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links. One link has random jitter and latency issues, and is based on a wireless connection.
Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD-WAN rules? (Choose two.)
- A. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.
- B. Use the performance SLA targets to detect latency and jitter instantly.
- C. Configure an SD-WAN rule to load balance all traffic without VoIP.
- D. Place the troublesome link at the top of the interface preference list.
- E. Choose the suitable interface based on the interface cost and weight.
Answer: A,B
NEW QUESTION 35
Which statement reflects how BGP tags work with SD-WAN rules?
- A. VPN topologies are formed using only BGP dynamic routing with SD-WAN
- B. BGP tags match the SD-WAN rule based on the order that these rules were installed.
- C. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
- D. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
Answer: B
NEW QUESTION 36
......
NSE7_SDW-6.4 Dumps Updated Practice Test and 37 unique questions: https://www.torrentexam.com/NSE7_SDW-6.4-exam-latest-torrent.html
